# How to Replace the Thermal Fuse on a GE Electric Dryer
The thermal fuse inside a GE electric dryer is a safety device that can shut off the dryer if it is producing too much heat. This prevents a possible fire due to high heat. If the thermal fuse is blown or broken, it must be replaced with a new part in order for the dryer to operate.
Things You'll Need
- Phillips (cross-head) screwdriver
- Needle-nosed pliers
Instructions
-
-
1
Disconnect the dryer power cord from the electrical outlet.
-
2
Open the dryer door. Remove the screws on the underside of the top panel.
-
3
Lift the top panel up and back to rest on its rear hinges or set against the wall behind the dryer.
-
4
Disconnect the wire connectors leading to the thermal fuse with the needle-nosed pliers. The thermal fuse is located in the back of the cabinet next to the heating element.
-
5
Remove the screw holding the thermal fuse to the GE dryer cabinet. Lift the old fuse out of the dryer.
-
6
Plug the wire connectors into the new thermal fuse. Connect the fuse to the dryer cabinet with the screw.
-
7
Replace the top panel onto the GE dryer cabinet. Install the screws that hold the panel in place.
-
1
Appliance Repair
- How to Bypass the Thermal Fuse on a Whirlpool Senseon Electric Dryer
- How to Bypass the Thermal Fuse on an Admiral Dryer
- How to Replace the Thermal Fuse on a Kenmore Microwave
- How to Replace the Thermistor in a Dryer
- How to Replace the Thermal Fuse in a Sony Wega KDF-E60A20
- How to Replace the Thermal Limiter in a Frigidaire Front Load Dryer
- How to Replace the Thermocouple on a Maytag Electric Performa Dryer
- How to Replace the Thermal Fuse on an Amana Gas Dryer
- How to Replace the Heater Assembly on a Whirlpool Electric Dryer
- How to Replace a Thermo Fuse on a Maytag Performa Electric Dryer
- How to Replace the Thermal Limiter in a Kenmore Dryer
- How to Check the Thermal Fuse on a Maytag Dryer
