Removing the Tub From a Calypso Washer

The Calypso line of washing machines is manufactured by the Whirlpool Corporation. Some models are branded as Whirlpool appliances and others are sold under the Kenmore brand. For some repairs and part replacement procedures, the wash tub must be removed from the washer. The tub can be replaced inside the washer cabinet after the needed repair or service is completed.

Socket wrench
Flat-blade screwdriver
Phillips screwdriver

Instructions

- 1
  Disconnect the washer power cord. Slide the washer 1 to 2 ft. away from the wall.
- 2
  Pry the brand emblem off the top of the front panel with the flat-blade screwdriver. Remove the screw that was under the emblem.
- 3
  Pull the top panel forward one-half inch. Lift the front of the top panel up until it stays in the open position on its rear hinges.
- 4
  Remove the four screws along the top of the front panel. Lift the front panel up to disengage it from the base. Set the front panel aside.
- 5
  Unhook the water inlet hose in the left rear portion of the top of the tub.
- 6
  Unsnap the locking tabs around the top edge of the tub. Lift the tub ring out.
- 7
  Unhook the three tabs around the edge of the balance ring at the top of the tub with the flat-blade screwdriver. Lift the balance ring out of the washer.
- 8
  Insert the tip of the flat-blade screwdriver into the notches at the base of the agitator dome. Pry the dome off and remove it.
- 9
  Remove the six bolts holding the outer wash plate in place at the base of the tub. Lift the plate out of the Calypso washer.
- 10
  Loosen the spanner nut holding the universal joint assembly in place at the base of the tub with the socket wrench. Remove the spanner nut. Lift the joint assembly out.
- 11
  Lift the tub straight up to remove it from the washer cabinet.

How to Disassemble a Frigidaire ATF6700FS Washer

How to Remove a Kenmore Cooktop

Appliance Repair