How to Disassemble a Whirlpool Front Loading Dryer

Whirlpool manufactures a wide range of both gas and electric dryer models. Each model is equipped with a distinct set of features and available cycle options. When components need to be inspected, tested or replaced, the outer cabinet must first be disassembled. With the dryer taken apart, internal components such as the motor, belt and heating element can be accessed to allow the unit to be serviced.

Flat-blade screwdriver
Phillips screwdriver

Instructions

- 1
  Unplug the power cord from the electrical outlet.
- 2
  Remove the screws at the base of the control console on the right and left ends.
- 3
  Pull the control console toward the front of the Whirlpool dryer to unhook it from its rear clips. Flip the console back to rest on its rear hinges behind the dryer.
- 4
  Remove the screws along the back of the top cover.
- 5
  Slide the top cover toward the front of the dryer. Lift the cover up to remove it.
- 6
  Insert the tip of the flat-blade screwdriver between the toe panel and the upper front panel. Press the screwdriver into the two spring clips located about 4 inches from each end.
- 7
  Pull the toe panel away from the dryer to remove it.
- 8
  Unhook the two springs leading from the base of the dryer to the upper front panel.
- 9
  Remove the screws connecting the front panel to the dryer cabinet. Unhook the door switch connector.
- 10
  Lift the front panel off of the Whirlpool dryer cabinet.
- 11
  Move the idler pulley toward the left to release drum belt tension. Slide the belt from the pulleys.
- 12
  Lift the drum out of the cabinet.

How to Replace a Foam Gasket for a Glass Cooktop

How to Replace the Oven Ignitor in a Maytag Range

Appliance Repair