How to Repair the Belt on an Admiral Capacity Plus Washer

Disconnect the Admiral washer from the power outlet.

Insert the tip of a putty knife between the front and top panels. Lift the putty knife up at the right and left corners to unhook the internal clips.

Lift the top panel up until it rests on its hinges.

Remove the screws along the bottom edge of the front panel. Lift the bottom of the front panel away from the washer. Pull the panel down to disconnect it from the cabinet. Set the panel aside.

Disconnect the springs at the base of the cabinet.

Disconnect the electrical harness leading to the motor. Remove the bolts holding the motor to the washer cabinet.

Slide the belt off the pulleys. Collect any broken belt pieces from the washer base.

Position the new belt around the pulleys. Replace the bolts holding the motor in place. Plug the electrical connector into its socket.

Replace the springs at the base of the washer. Replace the front panel. Install the screws that hold it in place. Lower the top panel onto the washer. Press down on the top of the panel to engage the internal clips.