Unplug the power cord. Remove the three screws along the back of the top panel. Lift the top panel up and back to remove it.
Unplug the ribbon cable in the back of the control panel assembly. Remove the two screws in the upper front corners of the control panel. Lift the control panel up to remove it.
Unplug the door switch electrical connector in the upper left corner of the dryer cabinet.
Remove the four screws that hold the front panel in place. Lift the front panel off the cabinet. Set the panel down with the inside facing up.
Peel the old felt seal out of the bearing assembly. Collect any broken pieces.
Press the new felt seal along the bearing assembly under each of the locking tabs.
Reposition the front panel on the Hotpoint dryer cabinet. Install the four screws holding the panel in place.
Plug the door switch connector into its electrical harness. Replace the control panel. Plug the ribbon cable into its connector. Install the screws holding the panel in place.
Replace the top panel. Install the screws holding the panel to the dryer cabinet.