# How to Adjust a Kenmore Dryer Air Shutter
An air shutter on a dryer controls the airflow to the flame in the gas burner. They are only available on Kenmore gas dryers that run on either propane or natural gas. If the gas flame doesn't get enough air, it will blow out because the flame needs oxygen to light. If the gas flame gets too much air, it will burn too hot and create soot inside your dryer.
Things You'll Need
- Phillips screwdriver
Instructions
-
-
1
Unplug the dryer from the electrical outlet.
-
2
Lift the cover plate off the bottom of the Kenmore dryer. Loosen the screws that hold the panel over the gas flame. Remove the panel.
-
3
Locate the air shutter, which is the little panel next to the gas flame. Use the screwdriver to turn the screw on the air shutter to the right to reduce the airflow, or to the left to increase the airflow to the flame.
-
4
Place the panel back on the door and screw it in place. Place the cover plate back on the dryer.
-
1
Appliance Repair
- How to Disconnect the Lines From a Kenmore Dryer
- Setting Up a Kenmore Dryer
- How to Replace Gas Coils on a Kenmore Dryer
- How to Get to Belt on a Kenmore 400 Series Gas Dryer
- How to Check the Fuse or Circuit Breaker in a Kenmore Gas Dryer
- How to Adjust a Dryer Regulator
- How to Remove a Kenmore Cooktop
- How to Clean a Flame Sensor
- How to Adjust the Flame on an Old Antique Kenmore Gas Space Heater
- How to Change the Flame Sensor on a Gas Dryer
- How to Remove a Kenmore Gas Dryer Blower Assembly
- How to Troubleshoot a Kenmore LG Gas Dryer
