How to Replace the Front Felt Seal on a GE Gas Dryer

GE automatic gas dryers are produced in a wide range of models, each with a distinct set of features and design characteristics. Every model is equipped with a felt seal on the front of the drum. A damaged or worn out seal may lead to noisy operation as the drum rotates. A faulty seal may also unbalance the drum, preventing it from rotating smoothly. Replace the worn out or damaged seal with a new part to keep your GE gas dryer running smoothly.

Phillips screwdriver

Instructions

- 1
  Disconnect the power cord from the wall outlet.
- 2
  Remove the screws at the back of the control panel. Lift the plastic trim off the back of the panel.
- 3
  Remove the two screws from the top panel. Lift the top panel off the GE gas dryer.
- 4
  Unplug the two electrical wire connectors leading to the front panel.
- 5
  Remove the screws on the ends of the control panel. Lift the control panel up and back. Rest the panel on top of the dryer.
- 6
  Remove the four screws holding the front panel to the cabinet. Lift the front panel up and away from the dryer to remove it.
- 7
  Position the front panel so the inside is facing you. Peel the felt seal out of the grooves along the bearing housing.
- 8
  Position the new felt seal in the old seal's place. Press the seal down to fit under the tabs around the edges of the bearing housing.
- 9
  Replace the front panel onto the GE dryer. Install the four screws holding the panel in place.
- 10
  Replace the control panel in its original position. Plug the two electrical wires into their sockets.
- 11
  Replace the top panel. Install the screws holding the panel to the cabinet. Replace the plastic trim along the back of the control panel. Install the screws that hold the trim in place.

How to Replace a GE Ice Maker Control Valve

How to Install Glow Plugs in a Whirlpool Dryer

Appliance Repair