How to Replace Gas Coils on a Kenmore Dryer

Kenmore gas dryers are manufactured in a wide range of models, each with a distinct set of features and cycle options. Each model is equipped with a set of gas coils, or solenoids, that control the gas valve to regulate the flow of gas. If the coils are defective or damaged, the dryer will not produce heat. Replace the faulty gas coils with new parts to restore your Kenmore gas dryer to working condition.

Phillips screwdriver
Putty knife

Instructions

- 1
  Unplug the power cord. Turn off the gas supply to the dryer.
- 2
  Lift the lint screen out of the top of the dryer. Remove the two screws next to the lint screen compartment.
- 3
  Place the putty knife along the seam between the top and front panels. Press the knife into the internal clips 2 inches from each front corner.
- 4
  Lift the top panel up and back out of the way.
- 5
  Remove the screws holding the front panel to the Kenmore dryer cabinet. Lift the front panel off.
- 6
  Unplug the electrical wires connected to the gas coils under the drum on the left side.
- 7
  Remove the screws holding the coils in place. Lift the coils off their shafts.
- 8
  Slide the new gas coils onto the coil shafts. Install the screws that hold the coils to the burner assembly. Plug the electrical connectors into the coils.
- 9
  Replace the front panel. Install the screws that hold it in place.
- 10
  Pivot the top panel back onto the cabinet. Install the screws next to the lint screen compartment.

How to Replace a Cracked Glass Cooktop

How to Install an Ignitor on an Amana Range

Appliance Repair