Instructions for an Ionic Breeze GP

Ionic Breeze GP Setup

• 1

  Place the Ionic Breeze GP at least 12 inches from the wall or any flat surface and in a location where children are not able to look or gaze directly into the air purifying unit.

• 2

  Plug the Ionic Breeze GP into a grounded 110-volt outlet.

• 3

  Switch the mode control to the desired setting which is either "On" or "On GP." "On" will circulate the air, but the germicidal lamp will be shut off. "On GP" will circulate the air and turn the germicidal lamp on so it kills germs as the air circulates.

• 4

  Switch the power controls to the desired setting which is either hi, med or lo. Hi pushes air through the system at a fast right, med does the same thing but at a moderate rate and lo produces the same effect but at a slower rate.

• 5

  Press boost to override the system's normal power controls and run the system at maximum for five minutes. This option is great for cleaning out the area within a short period of time.

Cleaning the Grid

• 6

  Unplug the unit before you begin to clean it.

• 7

  Remove the collection grid by pulling it from the top of the unit.

• 8

  Use a dry or slightly damp towel or sponge to quickly wipe the dust from each of the three collection bars.

• 9

  Flip the unit over and shake it a little to remove any dust or soot particles that may still be held within it.

• 10

  Allow the grid to dry for 24 hours before reinserting it into the unit for further use.