Unplug the Danby air conditioner from the wall.
Remove the plate cover on the lower rear section of the Danby air conditioner near the power cord to expose the connection terminals.
Open the back panel on the temperature control by first removing the screws with a Phillips screwdriver.
Cut four lengths of American Wire Gauge no. 12 and strip the ends of each wire with wire strippers about an inch.
Connect the four wires to the positive and negative terminals on the lower terminal blocks on the temperature controller. Connect the ends of these wires to the corresponding terminals on the inner panel of the air conditioner, which will be clearly marked.
Replace the backs on the temperature controller and the air conditioner.
Mount the temperature controller to the side of the air conditioner with Velcro strips or screws.