Set the carburetor on a work bench and use a screwdriver to remove the high-speed needle and seat at the top of the carburetor.
Loosen then remove the float bowl on the bottom of the carb with a screwdriver. Allow the excess gasoline inside the float bowl to drain into the drip pan.
Scrape the old float-bowl gasket off with a putty knife.
Clean the float bowl well with spray carburetor cleaner and a wire brush. Install the new gasket from the kit.
Remove the carburetor jets with the screwdriver. Clean the jets and spray out all jet ports on the carburetor with the cleaner.
Replace the carburetor jets with the screwdriver.
Insert the new seat and high-speed needle from the kit with the screwdriver.