# How to Remove the Cover From a Green Craftsman 5.0 HP Gas Snow Thrower
Things You'll Need
- Socket wrench
- Wrench
Instructions
-
-
1
Remove the three hex-head screws securing the chute to the top cover of the Green Craftsman 5.0 HP gas snow thrower with a socket wrench. The chute is the portion of the snow thrower that blows snow away from the machine.
-
2
Turn the fuel cap counterclockwise and remove it from the unit. Locate and remove the two hex-head bolts on the top front of the cover with the socket wrench. Place a wrench around the nuts underneath the bolts to prevent the nuts from turning while loosening the bolts.
-
3
Find the two bolts on the front sides of the cover. Remove the bolts and nuts with the wrench and socket wrench. Locate and remove the four bolts on each side of the cover and the five bolts on the back of the cover facing the handles.
-
4
Lift the rear of the cover over the fuel tank and pull the cover completely off the Craftsman snow thrower.
-
1
- How to Remove Tires From Snow Blowers
- How to Remove Snow From the Roof of a Two-Story House
- How to Remove Ice From the Roof & Gutter
- How to Replace the Chute on a 10/28 Craftsman Snow Thrower
- How to Change the Oil on a Craftsman Snow Thrower
- How to Remove the Auger Belt from a Craftsman Snow Thrower
- How to Remove the Snow From a Trailer Rooftop
- How to Remove the Impeller From a Craftsman 536.887990
- How to Replace the Drive on a Craftsman Snow Thrower
- How to Remove a Craftsman Snow Thrower Auger
- How to Remove Snow From an Above Ground Pool
- How to Remove the Cover From an Outdoor Receptacle
