Mix 1 gallon of gasoline and 2.7 ounces of two-cycle oil in a gas can and shake it slightly.
Open the gas cap on the Super XL, fill the tank with gas, then put the gas cap back on.
Open the bar oiler cap and add bar oil if needed.
Set the chainsaw on flat ground and hold the handle with your left hand. Prop one foot against the rear case of the saw to hold it in place.
Flip the ignition switch to the "On" position, then press the Super XL's primer bulb seven times.
Set the saw's chain brake to the "On" position and pull the choke lever all the way out.
Pull the recoil starter rope while squeezing the throttle a few times. Set the choke lever to the halfway position, then pull the recoil starter rope until the saw starts.