Toro Snowblower Choke Won't Close

Use the pliers to grasp the Toro snow blower's spark plug boot and then pull the boot off the top of the spark plug.

Use the screwdriver to remove the screws holding the snow blower air filter cover in place. It is located at the top rear of the Toro snow blower. Pull the air filter out by hand and set it aside.

Use a screwdriver to remove the two screws holding the air filter casing to the carburetor. This will give full access to the choke lever.

Use the tip of the screwdriver to dig out any dirt or grime that is in the path of the choke lever. Gently try to move the choke lever with one hand while clearing out debris with the other hand. Also, look to see that the choke lever is still intact at its base, where it connects to the carburetor.

Spray a small amount of spray lubricant, like WD-40, onto the choke lever as you try to work it back and forth until it moves freely. If the base of the choke lever is not attached to the carburetor, or if it is severed or cracked, proceed to the next step.

Use the pliers to pull the base off the old choke lever from the small metal tube it is attached to on the carburetor. Fit the base of the new choke lever to the small metal tube on the carburetor and use a pair of pliers to work it snugly into place.

Hold the air filter case in place and slip the two fastening screws into place on the carburetor. Tighten the screws down with the screwdriver. Fit the air filter in place by hand and then replace the air filter cover. Also re-attach the spark plug boot on the top of the plug.