How-to for a Antique Wringer Washer Fountain

Clean the antique wringer washer machine, especially the tub sectio,n if you plan on putting any fish inside. Remove any loose pieces of rust with fine steel wool. Vacuum up any loose pieces of rust so that they don't clog up the intake tube and filter of the water fountain pump when set up.

Seal any openings in the wringer washer tub with waterproof sealant. Allow to dry completely before placing any water in the tub.

Attach the clear plastic tubing to the output valve of the water fountain pump. If in doubt as to the location of the output valve, check the instructions that come with the water fountain pump.

Place the water fountain pump near the rear of the antique wringer washer tub so that it will be less noticeable.

Run the electrical cord and plastic tubing up and over the back wall of the wringer washer.

Open the wringer section large enough for the plastic tubing to be placed between the rollers of the ringer.

Fill the washer tub with water.

Plug in the water fountain pump. Use an extension cord that has been approved for use outdoors.

Place the plastic tubing between the wringers where you get the best waterfall effect. You may have to trim the plastic tubing with scissors. Most water fountain pumps will have a valve to adjust the flow of water.

Secure the plastic tubing between the wringers by screwing small metal clips with a screwdriver into the back of the antique wringer washer. This will hold the tubing in place.

Secure the electrical cord to the wringer washer by attaching it to the backside of the washer, on the outside. Keep the electrical cord tight against the washer so it doesn't get accidentally pulled out and is less obvious.