# How to Remove the Trimmer Head to Restring a Line in a Stihl KM110R
The STIHL KM110R is part of the company's KombiMotor lawn tool series. The handheld tool is equipped with a small, four-cycle engine on one end above the handlebars and controls, with a split-design connector near the ground. The connector works with a variety of optional attachments, including a string trimmer for slicing through weeds. The trimmer attachment disconnects from the main tool in seconds for replacing the line.
Instructions
-
-
1
Shut off the KM110R engine by pulling the throttle lever back to the "Off" position.
-
2
Disconnect the wire from the tip of the spark plug on the back of the engine.
-
3
Raise the black lever on the shaft of the power tool where it connects with the trimmer attachment.
-
4
Press and hold the spring-loaded locking buttons on the side of the shaft with one hand while hold the trimmer attachment with the other.
-
5
Pull the trimmer attachment off the drive shaft of the KM110R.
-
6
Unscrew the base cap on the trimmer head to expose the line reel for restringing. Wrap new line counterclockwise on the spool.
-
1
Lawn Mowers
- How to Load Trimmer Line on Stihl Trimmers
- How to Rewind the Twine on a Stihl Weedeater
- How to Remove the Cutting Head on a Ryobi String Trimmer
- How to Remove the Cap to Replace the Line of a Homelite Trimmer
- How to Replace the Line Trimmer Head on a Craftsman 25cc Line Trimmer
- How to Take a Weed Eater Head Off to Fix the Cable
- How to Remove the Bump Head Off of a Weed Eater
- How to Remove the Head of a Stihl FS-55R
- How to Change the Line on a Troy-Bilt 4-Cycle Gas Trimmer
- How to Remove the Head on John Deere Weed Eater
- How to Replace the Line on a Snap & Go Trimmer
- How to Remove the Spool to Replace a Line for a Grass Trimmer
