Directions for Setting Up a 10x20 ShelterLogic Canopy

Assemble the three-piece longitudinal roof members by inserting the end pieces--part 13103--into each end of the center piece--part 13106--until they are fully seated. Repeat this procedure for all six longitudinal members.

Assemble the two-piece rafter poles--parts 13103 and 13104--by pushing them together until fully seated.

Push two assembled three-piece longitudinal roof members into each end of a four-way frame connector--part 13102--until fully seated. Repeat this procedure for all three four-way connectors, which will leave you with three 20-foot-long longitudinal roof members. Push a three-way frame connector--part 13101--onto each end of all three 20-foot-long sections until fully seated.

Lay the 20-foot-long sections onto the ground parallel with each other and approximately 5 feet apart. Connect the three-way frame connectors on the ends and the four-way frame connectors in the center with the assembled two-piece rafter poles. Push the connections together until fully seated. The roof section is now complete.

Push the two leg pieces--parts 13103 and 13105--together until fully seated. Push the leg base foot--part 10075--onto the end of bottom of the leg--part 13103--until fully seated. Repeat this procedure for all six legs.

Have a helper raise one side of the roof assembly. Push the assembled legs into the three frame connectors on the raised side until fully seated. Now have the helper raise the other side of the roof so you can push in the other three legs.

Place the completed canopy framework in your desired location. Securer each corner of the canopy to the ground with the anchors provided. Place the roof cover over the top of the canopy and line it up so there is equal overhang on each side. Secure the cover to the framework with the cover’s built-in bungee cords.

Wrap the cord that hangs at each corner of the cover around corner leg poles. Place the “S” hook at the end of the cord into the slot in the corner leg. Twist the corner leg to tighten the cover and make it taut on the framework. Repeat this procedure for each corner leg. Twist each leg equally so the cover stays aligned on the framework.