How to Make a Resin Topped Table

Measure the table to determine how much resin you will need. One gallon of resin will cover just over six feet with a 1/4-inch thick layer of resin. Measure the area you want to cover and divide it by six. This is the number of gallons you will need. Always round up if you do not arrive at an even number.

Cover the edges of the table with the plastic edging and secure it with duct tape. The plastic edging should come up higher than the resin.

Test the plastic edging by pouring water onto the table. If the water leaks out anywhere, repair the area with duct tape and more edging, if needed. Repeat the water test until there are no leaks.

Cover the inside of the edging with petroleum jelly or another greasy material. This will allow you to pull off the edging once the resin is dry without harming the actual resin surface.

Mix the resin according to the manufacturer's instructions.

Pour the resin mixture onto the table area. Place a fan near the table. Turn it on so it blows over the table, keeping the temperature constant and cool. Hot spots can cause the resin to crack.

Remove the plastic edging after one week. While the resin is drying, make sure nothing touches the area, as that could cause dents.

Sand the edges of the resin to create a smooth finish. The top should not need any sanding.

Apply a top coat if the table will be in direct sunlight. Sun can cause resin to yellow, but a top coat, which can be purchased when you buy the resin, will protect the new tabletop.