How to Upholster a Coffee Table into a Footstool

Affix the Batting

• 1

  Measure the length and width of the coffee table top.

• 2

  Cut squares or rectangles of quilt batting to the exact same size as the table top. High-loft batting is usually about 1 inch thick; cut enough layers of batting to form a pile 4 inches high.

• 3

  Squirt craft glue all over the table's surface. Don't worry about creating a neat pattern. Just draw scribble lines of glue all over the top, leaving about a 2-inch border between the outer glue lines and the edge of the table.

• 4

  Center one layer of quilt batting on top of the coffee table. Press it down gently so that the glue seeps into the batting.

• 5

  Add glue to the top of the quilt batting in the same manner that you used to put it on the table top. Add another layer of quilt batting on top of the first.

• 6

  Squirt more glue onto the batting and add another layer of batting on top of that. Continue adding layers of batting until you have a stack glued onto the table top that is about 4 inches thick. Allow all of the glue to dry thoroughly, or at least overnight.

Cover with Fabric

• 7

  Add 6 inches each to the length and width of the table top. Cut a piece of upholstery fabric to these new dimensions.

• 8

  Lay the fabric print- or colored-side-down on the floor or on another large, flat surface.

• 9

  Turn the coffee table upside down and set it on the piece of fabric. Make sure that the table is centered exactly in the middle of the fabric piece.

• 10

  Hold the center of the table down with your left hand and pull the right edge of the fabric up and over to the underside of the table. Let go of the table. Hold the fabric edge in place and use the staple gun to staple the center of the fabric's edge to the underside of the table.

• 11

  Pull the left edge of the fabric toward the underside of the table, pulling the fabric taut to remove any loose fabric or wrinkles on top. Staple the center of this edge to the underside of the table. Do the same thing with the top and bottom edges of the fabric, as well.

Finishing

• 12

  Pull the right edge of the fabric taut and add a line of staples across the right side of the underside of the table. Place each staple 1/2 inch from its neighbor, creating a continuous line. Stop stapling when you are 1 inch from each corner.

• 13

  Staple down the left side of the fabric onto the left side of the table underside. Do the same with the top and bottom edges, as well. Stop stapling when you reach 1 inch from every corner on each side.

• 14

  Neatly fold the corners down by smoothing one edge in one direction, then folding the flap it creates down toward the center of the table's underside. Staple this flap down, pulling it toward the center of the table.