How to Stop Drawers From Pulling Out

Drawers are designed to pull out but shouldn't pull all the way out and fall. Older furniture and cabinets drawers often rode on a center track that allowed the drawer to be pulled out, but it didn't stop the drawer from falling. This problem is corrected with a stop block. This is a simple wood device that is attached to the inside back of the drawer and will block the drawer from easily falling forward and out. The stop block can be turned to allow the drawer to be fully removed when necessary.

Things You'll Need

• 1/2-by-3/4-by-2-inch wood piece
• Drill
• Screw
• Screwdriver

Show More

Instructions

1. • 1

     Cut a wood block that is 1/2-by-3/4-by-2-inches.

   • 2

     Drill a hole in the block that is centered and 1/2 inch from one end.

   • 3

     Screw the block to the rear of the drawer so that 1/2 inch of the block is above the back board of the drawer. Tighten the screw enough that the block stays in place but loose enough for you to turn the block horizontally with your fingers.

   • 4

     Slide the drawer into the cabinet or chest with the block horizontal. Reach into the drawer and turn the block vertical. This will block the drawer from pulling out.