Simplicity for Children Bassinet Instructions

Lower Frame and Basket Assembly

• 1

  Unpack all parts and check to make sure you have each piece. Lay out on the floor for easy assembly.

• 2

  To assemble the rocker, insert each support tube into the opening of the rocker base. For proper assembly, ensure the basket tube clips face inward. Insert the large assembly bolts through the base and leg to lock in place.

• 3

  Locate the cross tubes (they have threaded ends). Line up the cross tubes with the holes in the support tubes. Screw each cross tube into the support tube.

• 4

  Locate and slide the two basket tubes into the flaps of the accessory basket. Click the basket tubes into the tube clips on the rocker base. You will need remove the large assembly bolts and screw the bolt into the end of each basket tube. Be sure to tighten all bolts for safety.

• 5

  Attach the basket straps to the support tubes and pull tight.

Master Control Unit Assembly

• 6

  Locate master control unit and unscrew base. Find the screw holes on the fixed top rail of the bassinet; slide the master control onto the rail and line up the screw holes. Fasten the unit to the base using two base assembly screws.

• 7

  Install the fabric assembly in the basket frame by lining up the fabric with the mattress support rockers. Drape the fabric over the basket frame and fold over the removable cross tube. Push the fabric into the basket, locate the elastic band and pull down tightly, securing the fabric around the master control unit. Be sure the fabric is snug to ensure safety.

• 8

  Pull fabric over the frame and snap in place. Line up the canopy openings with the canopy anchors.

• 9

  Place mattress in the bassinet basket.

• 10

  To attach the basket assembly to the bottom assembly, slide the two plastic attachment hooks around a cross tube and push down. If done correctly, the basket assembly should catch the latch on the other cross tube. Check this by pulling up on the basket assembly to ensure it is locked into place.

Electronic Accessory and Canopy Assembly

• 11

  To install the vibrating motor, unwrap the cord from the motor, located at the bottom of the mattress support. Thread the cord through the fabric slit and attach to the master control unit.

• 12

  To operate the master control unit, push the switch to the desired setting. The top button operates the light bulb feature, the left button operates the vibration settings and the right button operates the musical mode.

• 13

  To attach the canopy, locate the anchors on either side of the basket frame. Holding each side of the canopy, insert the bottom of the canopy bracket into the anchor through the fabric slit. Push down until you hear a click. Pull up to ensure it locked into place and stretch the canopy fabric over.