Storkcraft Lennox Stages 3 in 1 Crib Assembly Instructions

Examine the contents of crib packaging to make sure you have all necessary parts. The Crib comprises one headboard, one footboard, one short drop-side rail and one long stationary side rail. Mattress parts include one mattress base, two mattress base supports, two mattress base brackets each for the left and right sides. There should be two installed upper T-rails; one lower left-installed T-rail, one lower right-installed T-rail, two left-installed claws, two right-installed claws, two double bed footboard posts, four casters, one guard rail, 12 1/4" x 5/8" bolts, four 1/4" x 1 3/4" bolts, eight 1/4" x 3-1/8" bolts, eight Barrel nuts, four Acorn nuts, eight Lock washers, two 1/4" x 2-3/8" bolts, two wooden dowels, one shaped cross rail and one allen key.

Inspect the crib for damaged hardware, loose joints or sharp edges. Do not use the crib if any parts appear broken. For replacement parts, visit the Storkcraft website for replacement part information. Do not substitute parts on your own. The Storkcraft Lennox Stages 3-in-1 Crib is guaranteed with a limited one-year warranty from the date of the original purchase and will repair or replace any defective part free of charge.

Install the mattress base brackets. Place the mattress base supports on an even surface. Place the mattress base with the warning label facing upward. Line up the corner holes of each mattress base support with the mattress base. Fit the left and right mattress base brackets to the mattress base supports and the mattress base, so that the hooked ends face outward. Insert a 1/4" x 1 3/4" bolt through both the left and right mattress brackets, mattress base and mattress support, for a total of two bolts. Secure a lock washer and an Acorn Nut to each 1/4" x 1 3/4" bolt. Tighten the bolts with a slotted screwdriver and an adjustable wrench. Do not over-tighten.

Set up the stationary side rail. Insert four wooden dowels Into the outer holes of the stationary side rail. Affix the stationary side rail to the footboard by placing the wooden dowels to the corresponding holes in the footboard. Insert the Barrel Nut In the hole of the stationary side rail. From the outside of the footboard, insert the 1/4" x 3-1/8" bolts and tighten with the provided allen key. Repeat the same steps on the other side of the stationary side rail. Attach the headboard into the other end of the stationary side rail.

Assemble the shaped cross Rail. Insert two wooden dowels halfway into both ends of the shaped cross rail. Loosen the bolts of the stationary side rail without completely un-installing the rail. Position the shaped cross rail between the headboard and the footboard with the wooden dowels inside the lower holes. Attach the shaped back rail with the two 1/4" x 2-3/8" bolts. Use the allen key to tighten the bolts.

Assemble the mattress base. This step requires two people. Place the mattress support with the warning label face up. Secure the mattress base between the headboard and the footboard. Put a lock washer onto each of the 1/4" x 5/8" bolts for each of the four corners. Insert the bolts with the lock washer through the holes of the footboard and headboard. Do not overtighten. A nut inside the headboard and footboard is pre-installed.

Set up the drop-side rail by ensuring that the plastic teething rail is upright just above the lower and upper T-rails on the headboard. Fit the upper and lower claws on the drop-side rail onto the upper and lower T-rails on the headboard. Lock the drop-side rail into place by lowering it down. Repeat these steps to assemble the footboard to the drop-side rail. Attach the four casters to the bottom of each corner post.