Instructions for Simmons Baby Bed Model 5326 94 42

Assembling a crib might seem like a complicated process with so many pieces and hardware, but this doesn't have to be hard as long as you follow the instructions. If you do not have your Simmons crib instructions because you bought the crib used or lost the instructions, you can still assemble your crib. Instructions can sometimes be found in the mattress support of the crib, but if they are not there or are not readable, you can assemble your crib by following some simple steps.

Allen wrench

Instructions

- 1
  Lay both crib ends on a flat surface on the floor. Insert the threaded end of the furniture pads into each of the four crib legs. Tighten with your hand.
- 2
  Attach the headboard of the crib to both ends of the crib. Align the headboard in between the sides, making sure to align the holes where the bolts go in, located on the top and bottom of each crib end. Find four bolts labeled M6 X 73 mm, which are included with the crib. Insert a bolt into each hole, for a total of four. Tighten with an Allen wrench.
- 3
  Secure the mattress support to the crib. Decide on a height for the mattress support. Choose the highest available for newborns, and move lower as your baby grows. Align each corner of the mattress support to the chosen hole for the height. Locate four bolts labeled M6 X 16 mm, included with the crib. Insert a bolt into each hole. Tighten with an Allen wrench.
- 4
  Install the footboard of the crib. Align the front side to the rest of the crib, making sure to align the holes for the bolts to go into. Find the last four M6 X 73 mm bolts included with the crib. Insert a bolt into each of the four holes, two in the bottom and two in the top of each side of the footboard. Tighten with an Allen wrench.

How to Build a Simple Murphy Bed That Fits Into Rustic Decor

Beds Vs. Futons

Beds