Directions for a Jardine Crib

Attach the left end panel to the stationary side by inserting two ¼ inch- by-1 ¼ inch bolts through the allotted slots on the stationary side and interior of the left end panel.

Turn the Allen key clockwise until the bolts are securely in place.

Attach the right end panel to the stationary side by inserting two ¼ inch-by 1 ¼ inch bolts through the allotted slots on the stationary side and the interior of the right end panel. Tighten the bolts into place by turning the Allen key clockwise.

Affix the stabilizing bar to the left end panel and right end panel by inserting a single ¼ inch-by-2 inch bolt through the designated slots on the exterior of each panel. Turn the Allen key clockwise again to secure the bolts into place.

Position the mattress support inside the crib so that the raised edges are facing downward and the tabs are pointing upward. Use the Allen key and four ¼ inch-by-½ inch bolts to secure each tab to the four corners of the crib.

Locate the ridges found on the interior front posts of the left end panel and right end panel. Align the drop slide with the bottom of each ridge and raise it until it locks into place.

Place the two rubber bumpers over the corresponding holes found in the lower ridges of the interior front posts. Secure the bumpers into place using two 3/16 inch-by-3/8 inch bolts.