Problems With Vibration on a BS100 Band Saw

Mount

• If the BS100 isn’t attached tightly to the workbench tightly, the saw vibrates, causing inaccurate cuts and machine instability. Upon installation of the BS100 to the workbench, the machine needs to be fastened securely to the bench or work surface via the four supplied holes at the base of the machine. If the workbench is made of wood, starter holes can be drilled into the wood; screws with lock washers can be installed through the holes into the wood. This prevents the machine from “walking” or sliding across the work surface during operation. If the machine is secured to the workbench and vibrates, the screws might require tightening.

Surface

• Proper installation of the BS100 band saw requires a flat or level surface. Should the band saw be installed at an angle or slightly uneven, the machine might vibrate during use, causing unsteady cuts and a dangerous situation. If the BS100 experiences vibrations, the work surface should be checked with a level and the machine should be relocated to a level surface.

Belt

• The drive belt on the BS100 band saw keeps the blade moving at a steady and strong pace. Should the belt wear out or break, the machine will vibrate, produce less than satisfactory results or fail to operate altogether. If you suspect that the belt needs to be replaced, you should first unplug the BS100 from its power source to cut off the flow of electricity into the machine. The BS100 can be opened down the center to reveal the wheel pulley and the belt component. The belt should be removed and replaced with a new belt, if it's broken or worn out.

Tension

• The BS100 belt might be perfectly in tact but require adjustment to prevent or correct machine vibrations. Using a wrench, you can loosen the two screws on the top and underside of the motor, which is the dark, cylindrical object protruding from the left side of the BS100. The motor can be rotated, until the tension of the belt is adjusted accordingly, then the two screws can be retightened.