How to Wire a Forward-Reverse Switch on a Crane Drill

The Crane drill is a small, hand-held electric drill made by the company of the same name. The drill is a cordless tool that recharges from a 120-volt power pack. The Crane drill does not require much maintenance. However, sometimes the forward-reverse switch can wear out on the unit. The forward-reverse switch is a button that reverses the spin of the drill head. If the switch does wear out, a replacement switch can be installed.

Things You'll Need

• Phillips screwdriver
• New switch

Show More

Instructions

1. • 1

     Remove the battery pack from the bottom of the handle by sliding it off.

   • 2

     Remove the screw beneath the trigger assembly and set it aside.

   • 3

     Pull the trigger assembly apart to access the forward-reverse switch.

   • 4

     Use a small Phillips-head screwdriver to remove the old switch. Set the new switch in place and fasten it with the retaining screw.

   • 5

     Close the drill and replace the trigger assembly screw. Replace the battery pack and then test out the new forward-reverse switch.