Can I Put Backer Board Over Drywall for Shower Tiling?

Moisture Barrier

• Traditional cement backer boards and fiber boards require some type of moisture barrier to be installed -- behind the board and against the studs on the wall -- to protect the wooden wall components from eventual water seepage. Installing the cement board tightly against the drywall affects the breathing aspect of the vapor barrier and traps moisture in, eventually rotting and crumbling the drywall.

Wall Thickness

• For most shower walls, the drywall installed in the home during the building phase is cut off at the edge of the shower opening, and then backer board is installed in place of the drywall in the wet areas. The backer boards are usually around a one-half-inch thick in both cases. If you install another layer of backer on top of drywall, the problem you will encounter is that the wall is now another half inch thicker, leaving an ugly reveal behind that has to be covered.

Reality of Tile

• The reality of tile installation is that tiles contain cement, which naturally breathes in and out and contains and expels moisture over the course of its life. Water is the bane of drywall’s existence, as it turns drywall into a gooey mass that falls apart if sufficient water is present. Cement backer boards, on the other hand, do not have this issue, which is why they are used instead of drywall, and never on top of drywall.

Alternatives

• A quick and easy alternative to removing old drywall and installing new backer board is to simply paint the surface of the drywall with a paint-on latex drywalling. This provides adequate protection for a tile installation as far as water is concerned, but only works if the drywall is in prime condition. Otherwise, remove the drywall, and use a waterproof-membrane system in place of the cement board; alternatively, use cement boards, as long as they have a vapor barrier.