How to Lay Brick Over Existing Tile

Wash the tile floor with a strong de-greasing detergent and rinse well with water.

Put on safety goggles, gloves, knee pads and a dust mask.

Rough the tile finish with a belt sander that uses a medium-grit sandpaper. Sand off the shiny surface only, to create a good bonding surface.

Sweep and vacuum the dust from the floor.

Mix self-leveling floor compound according to the package directions. Self-leveling floor compound, when mixed, yields a fairly thick yet runny consistency.

Apply a 1/4-inch even layer of self-leveling floor compound using a trowel. Self-leveling floor compound fills in depressions and runs away from high spots, creating the level flooring surface required for filling in grout lines. Begin in a far corner away from the door to avoid becoming stuck.

Allow the compound to dry fully, which usually takes 12 to 24 hours.

Mix mortar according to the directions on the bag.

Apply a thin coat of mortar, commonly called a skim coat, to the floor.

Apply a 1/4-inch-thick layer of mortar over the skim coat.

Drag the notched side of a trowel through the mortar to create lines in the floor.

Apply 1/4-inch mortar to the back of the brick with a trowel, referred to as "buttering the brick."

Set the brick in place. Continue to apply mortar and set bricks.