Tin Roof Removal

Remove nails or screws from edges of roof while standing on a ladder if possible. Remove all hardware that can be removed from while standing on a ladder before climbing onto the roof.

Climb onto your roof. Depending on the type of underlayment, stand only on the seams that contain screws or nails. Depending on the slope of your roofing, it may be necessary to use a harness or other safety gear to safety stand on the roof. Wear rubber soled or textured boots or shores. Take precautions to prevent injury from falling.

Remove nails or screws using a hammer, crow bar, or screw gun, depending on the type of hardware used, from the ridge cap at the peak of your roof first. Once these are removed, begin removing nails or screws from the tin roofing starting at the highest point first and working your way down. Stand only on pieces of tin that are still attached with screws. Do not stand on a piece where the screws are being removed as this piece is susceptible to sliding
once unsecured. Once the underlayment is exposed, stand on the underlayment.

Work your way across the roof removing one piece of tin at a time and handing the tin down to the ground. Use an assistant to help you when handing the tin down from the roof to prevent damage to siding or windows.

Place removed nails or screws in a nail pouch as you work to ensure they do not end up in your driveway or yard.