Blumotion Instructions

Remove the drawer from the cabinet or dresser. Turn it upside down so that the bottom of the drawer is facing upward. Using the installation hardware that comes with the Blumotion runners, screw the preparation pieces onto the drawer. The stop collar is put at the back of the drawer, usually on the right hand side, while it is upside down. The boring rear is also at the back of the drawer and installed at the same time and area as the stop collar. The locking device is on the opposite side of the drawer in the front, and the pilot boring is placed in the right top corner.

Put on the runners. The Blumotion runners are placed along the edges of the drawer so that it will slide easily in and out of the cabinet or dresser. Screw the runners into place on the bottom of the drawer. The runners are concealed when the drawer is opened or closed. The locking device and borings previously added prevent the drawer from pulling fully out of the cabinet.

Adjust the drawer height by pressing on the adjustment tab and then sliding or pushing to the back of the drawer. The height increases slightly.

Adjust the drawer tilt by turning the tilt adjustment lever to the left. The tilt adjustment lever is at the back of the Blumotion runner.

Remove the drawer after installation by pressing on the orange buttons or handles on the locking device. Pull the drawer out and then upward and it comes out. Replace the drawer by lining the drawer up with the locking devices and sliding it in.