Install the largest boards first to minimize the number of seams you create. Each seam requires sealing and several subsequent coats to hide the tape embedded in joint compound, so minimizing seams means less work for the drywall finishers.
Trim the board so its short edge, when installed, will rest halfway over a wood joist. Score the drywall’s paper face with a utility knife and then bend along the score line until it snaps. Leaving half the joist uncovered allows you to attach the next board in that series to the same wood joist.
Ask assistants to hold each board up to the ceiling so the long edge of the board is perpendicular to the wood ceiling joists. Have them butt each board as close as possible to the walls and adjacent boards to minimize gaps.
Install drywall screws every 6 to 8 inches along each joist, including the one that is half-covered. Each screw should penetrate through to the wood ceiling joists.
Fill with joint compound any large gaps around the corners of the installed ceiling, using a 6-inch drywall knife. It might take several coats before the corners are square and ready for the drywall finishers.