Can Coated Sinkers Be Used in Pressure-Treated Wood?

About Coated Sinkers

• Carpenters use vinyl-coated sinkers for general construction, primarily wood-frame house construction. A vinyl-coated sinker consists of a long, smooth shank covered with a vinyl coating. The vinyl coating helps the nails drive and sink into common framing materials smoothly. Sinkers typically have checkered or serrated heads. Friction encourages a hammer's striking face to grip sinkers' heads, which prevents bending. Vinyl-coated sinkers are typically manufactured from steel alloys.

About Preservative-Treated Lumber

• Governmental authorities banned the lumber industry's favored wood-preservation compound, called chromated copper arsenate, or CCA, because contact with arsenate can lead to arsenic poisoning. The most common replacement for CCA is called alkaline copper quaternary, or ACQ. While ACQ is less toxic than CCA, its high copper content accelerates the corrosion of metal fasteners. You can determine a treated board's preservative by reading its lumber stamp. The stamp will read either ACQ or CCA. Due to regulatory restrictions, CCA-treated products are no longer available in retail stores or lumber yards. However, you might find them installed in older homes.

Acceptable Fasteners for Preservative-Treated Lumber

• While vinyl-coated sinkers corrode from contact with pressure-treated wood, several corrosion-resistant fasteners are suitable for use with preservative-treated lumber products. For load-bearing or framing applications, building codes and manufacturers typically recommend hot-dipped galvanized fasteners or stainless steel fasteners. Alternatives to hot-dipped or stainless steel fasteners include copper or bronze fasteners. However, copper and bronze fasteners usually are not acceptable for residential framing or construction projects. Although relatively expensive, stainless steel fasteners exhibit the most resistance to corrosion. Note that electroplated galvanized fasteners have a thin protective layer and are less resistant to corrosion than are hot-dipped galvanized fasteners.

Where to Use Vinyl-Coated Sinkers

• Fastener manufacturers recommend vinyl-coated sinkers for interior carpentry and framing projects, such as stud wall construction. If you choose to use sinkers for exterior stud wall construction, remember that the wall's bottom plate might contact a treated sill plate. Avoid using coated sinkers for exterior projects. Sinkers not only corrode under exterior conditions, but also "bleed" streaks of rust and compounds across finished wood surfaces.