Instructions for a TrakRac T3 Miter Saw Stand

The Bosch TracRac T3 is a universal mounting stand that works with any miter saw on the market. When upright and ready for use, the TracRac T3 stand is 9 1/2 feet in length and provides a material capacity of 18 feet, a work support width of 12 inches and 15 1/2 feet of total out-feed width. The stand includes 4-inch rubber casters, 12-inch adjustable height supports, an adjustable leveling leg and universal mounting brackets.

Bosch TracRac T3 Miter Saw Stand
Miter Saw
Cutting Material

Instructions

- 1
  Open the legs on both sides of the stand. When you hear the brass pins click, the legs are in locked position.
- 2
  Turn the tool mount handles to the "unlock" position. The miter saw will not slide into the stand if the handles are in the "lock" position.
- 3
  Place the miter saw on the tool mount so the bottom of the saw engages the main beam. Tighten the tool mount handles.
- 4
  Place cutting material evenly on the stand. If the cutting material is too far to one side, the opposite end of the stand may be lifted off the ground. To avoid this, hold down the opposite side before cutting the material.
- 5
  Turn on the miter saw. Feed the cutting material through the miter saw to cut the material. Turn off the miter saw after use.

How to Stucco With Surewall and Lath

Why Use Water Repellents on Pre-Cast Buildings?

Building Materials & Supplies