Create a cutting guide on your bathtub. Bathtub saddles generally come with a template that users can trace onto the wall of a tub. Place the template over the side of the tub. The installation instructions may tell you to center the template, but it can also be off-center if doing so makes the shower simpler to access. Once you the template is in position, use a few pieces of masking tape to help hold it in place. Then use a permanent marker to trace along the edge of the template. Remove the template after you finish tracing its shape onto the tub wall.
Cut out the shape you drew on the bathtub wall using a handheld electronic saw. Wear safety gear – safety goggles, dust mask and work gloves – as you complete this task. Take your time as you cut so you cut only along the line that you drew on the tub.
Place the bathtub saddle in the opening you just created to verify that it fits.
Remove the debris from inside the tub and the bathroom floor, and wipe rubbing alcohol along the cut edges of the tub and the parts of the bathtub saddle that make contact. The rubbing alcohol will help remove excess dirt and oil from the surface of the fiberglass materials so the adhesive works better.
Using a caulking gun, apply a bead of waterproof silicone adhesive along the bottom of the bathtub saddle, along the edges that will touch the tub.
Press the bathtub saddle into place over the opening you cut to help spread the silicone adhesive.
Add a bead of silicone adhesive along the edge of the bathtub saddle and the tub to create a watertight seal. Then use a caulk-smoothing tool to eliminate any excess adhesive and create a smooth finish. Allow the adhesive to dry according to the manufacturer’s instructions before using the shower.